Innotech Maxim Manual do Utilizador descarregar pdf (Página 20)

MAXIM Installation Instructions

Page 20 © Mass Electronics Pty Ltd 2011Edition 2.0 dated 20/11/2013

2-3 General Installation Information

2-3.1 Overview

This section of the manual provides general installation guidelines to assist you with the mechanical

installation of the MAXIM Series controllers.

2-3.2 General Installation Guidelines

The following installation guidelines are provided to ensure continued and reliable operation of the

MAXIM Series controllers:

• The MAXIM I, II, III, and 1010 controllers should be installed in a position that provides easy

access to the optional HMI, and suicient room for power and input/output cabling. Placement

of the these controllers should account for the optimum viewing angle of the LCD, which is

approximately 80 ° vertically, and 80 ° horizontally, as illustrated in Figure 2-5 below.

• The controllers should not be exposed to high voltage, high current cables, or sources of strong

radio frequency emissions such as transmitter antenna cables.

• The ambient temperature of the MAXIM Series controllers at the installation site should not exceed

the normal operating temperature range recommended for the specific controller.

• The controllers should be installed in an area with minimum vibration and minimum exposure to

mechanical damage.

Figure 2-5: LCD Optimum Viewing Angle

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 59 60

Sem comentários

Innotech Maxim Manual do Utilizador Página 20